Cannon DIGI-TROLL 5 TS Manual do Utilizador

Owner’s Manual DIGI-TROLL 5 DIGI-TROLL 5 TS Owner’s Manual

10 www.cannondownriggers.com BOOM END PULLEY Telescopic Boom 1) Remove boom end assembly from hardware bag. 2) Remove #8 self tapping screw from ha

11 www.cannondownriggers.com REMOVABLE SPOOL COVER Your new downrigger comes with a removable spool cover. By removing this cover, you are able to

12 www.cannondownriggers.com Installation ATTACHING THE ROD HOLDER(S) The locking rod holder(s) incorporate a locking tooth design which can be easi

13 www.cannondownriggers.com Installation TERMINATING THE DOWNRIGGER CABLE TIP: Use only straight cable when routing through the terminator. Worn or

14 www.cannondownriggers.com USING YOUR DIGI-TROLL WITH THE INTELLITROLL ACCESSORY Both the Digi-Troll 5 and Digi-Troll 10 are compatible with the I

15 www.cannondownriggers.com USING THE INCLUDED POWER LOSS MANUAL CRANK HANDLE In case of a dead battery, your downrigger comes equipped with a powe

16 www.cannondownriggers.com Installation Wiring Your Downrigger Your Boat's Electrical Condition It is important to make sure that your boat

17 www.cannondownriggers.com Installation FUSE / BREAKER SPECIFICATIONS: An over-current protection device (circuit breaker or fuse) must be used wi

18 www.cannondownriggers.com GETTING STARTED Operating the Digi-Troll 5 The Digi-troll 5 offers you the most advanced features available in a downri

19 www.cannondownriggers.com Getting Started Digi-Troll 5 Keypad The Digi-Troll 5's keypad has six keys located below the display. Power The

2 www.cannondownriggers.com Table of Contents TABLE OF CONTENTS Introduction...

20 www.cannondownriggers.com Programming the Digi-Troll 5 The Digi-Troll 5 contains four menus that enable you to program and customize its operation

21 www.cannondownriggers.com Getting Started Positive Ion Control Menu This menu lets you control the PIC level from 0.2 vdc to 1.2 vdc. Press the

22 www.cannondownriggers.com Un/Coated Menu This menu lets you switch between Cannon coated and uncoated cable. This setting is important as well i

23 www.cannondownriggers.com Getting Started Networking your Digi-Trolls Up to six Digi-Troll series downriggers can be networked together with the

24 www.cannondownriggers.com Fishing With Your Downrigger After programming your Digi-Troll, release some line from your rod and reel so that the l

25 www.cannondownriggers.com How the Positive Ion Control System Works The PIC system uses an internal circuit that passes the voltage through the

26 www.cannondownriggers.com Blowback Simply stated, blowback is what happens to the downrigger weight when you pull it through the water behind yo

27 www.cannondownriggers.com Ten Good Trolling Tips 1) Test your lures over the boat side before sending them down and back. Do this to make sure the

28 www.cannondownriggers.com Troubleshooting PROBLEM: In the UP or AUTO-UP mode the downrigger stops periodically but the display stays on or the c

29 www.cannondownriggers.com THIS PAGE INTENTIONALLY LEFT BLANK

3 www.cannondownriggers.com Introduction Introduction Overview Thank you for purchasing the Cannon Digi-Troll 5 electric downrigger. We have design

30 www.cannondownriggers.com Parts List 1902315 Digi-Troll 5

31 www.cannondownriggers.com Parts List 1902315 Digi-Troll 5 In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121 Po

32 www.cannondownriggers.com Parts List 1902320 Digi-Troll 5 TS

33 www.cannondownriggers.com Parts List 1902320 Digi-Troll 5 TS In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121

34 www.cannondownriggers.com Wiring Diagram Digi-Troll 5 Series Wiring Diagram

35 www.cannondownriggers.com NOTES: ________________________________________________________________________________________________________________

www.cannondownriggers.com ENVIRONMENTAL COMPLIANCE STATEMENT: It is the intention of Johnson Outdoors Marine Electronics, Inc. to be a responsible co

4 www.cannondownriggers.com Product Warranty CANNON LIMITED WARRANTY Johnson Outdoors Marine Electronics, Inc. warrants to the original purchaser t

5 www.cannondownriggers.com Product Overview Introduction to Controlled Depth Fishing Undoubtedly there are many fishermen familiar with the method

6 www.cannondownriggers.com Installation Downrigger Mounting on Boats A downrigger should be mounted wherever it is easy to operate and observe. Yo

7 www.cannondownriggers.com Installation Decks thinner than 1/4" Use a Cannon deck plate (PN 2200693) to prevent deflection and add stability

8 www.cannondownriggers.com INSTALLING THE BOOM AND BALL HOOK 1) Remove the ball hook collar, ball hook, and 1/4-20 nut from the included hardware b

9 www.cannondownriggers.com FIGURE 5 FIGURE 6 FIGURE 7 FIGURE 8 6) Insert the 1/4-20 nylon locknut into the hex pocket on the nose of the frame (moto