Cannon VB-C500VD Guia de Configuração descarregar pdf (Página 75)

2-13

Motion Detection Setting Tool

VBAdmin Tools

(8)[Details]

When this check box is selected, you can enter [Sensitivity], [Size] and [Duration] values.

If the check box is not selected, [Duration (sec.)] is fixed to [0.2].

4. Check the motion detection status of the camera.

To check the level of motion detection operation based on the specified settings, select the

[Display motion detection status of the camera] check box. The motion detection status will be

shown by the icons specified below.

If the [Display motion detection status of the camera] check box is selected, the settings

cannot be selected. To save the settings, clear this check box.

Tip

z Even when a change has occurred in the image shown inside the viewer's motion detection

area frame, the camera will not recognize it as [Motion] if the [Sensitivity] setting is low.

Even when the sensitivity is raised, the camera mode will not change to [Detected] unless

the part of the area frame that has moved meets the [Size] and [Duration] settings for

motion.

z You can also select the setting area by clicking a desired motion detection area frame in

the viewer. The selected detection area frame is shown by blue solid lines.

z By setting the Selected areta to [Not specified], you can show the detection statuses for all

motion detection areas at once. Clicking a point in the viewer where no area frame is set

has the same effect.

Note

z If a proxy server is used, the video frame rate may drop depending on the proxy load.

Accordingly, it is recommended that you don't connect the camera via a proxy while this

function is set.

z It is recommended that the motion detection level be set in a condition as close as possible

to the condition in which the camera is actually used.

[Detection disabled]

[Detected]

[Not detected]

COPY

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 159 160

Sem comentários

Cannon VB-C500VD Guia de Configuração Página 75